1.The machine has the following characteristics:

The whole machine is in accordance with the requirements of high reliability, functionality and safety. The design and manufacture of rapid sheet alternation and convenient operation. The imported PLC control system, to achieve a "fool" operating system.

2.The drive shaft is made of high quality materials and accessories, all the drive rollers are made of high-quality steel, through static balance, dynamic balance test, stable and reliable operation, the surface after fine grinding, hard chromium plating.

3.Gear: the material is made of high-quality alloy steel 20CrMnTi, transmission gears with hard grinding. The Rockwell hardness greater than 60 degrees. The precision reached the National Grade 6. The gear box adopts gear pump, automatic spray lubrication, ensure each meshing of gear can be lubricated. To ensure that the printing of long-term overprint precision.

4.Electric control: the OMRON , SIEMENS, Taiwan FATEK PLC, Schneider famous brand CHINT appliances, to ensure stability and life of electrical operating system.

5.Bearing: main drive bearings with Japan NSK brand.

Technical parameter

Feed Unit

1.The most advanced feed system is from Taiwan

2.Draught fan can regulate wind power. It suits all kinds of paperboards.

3.Left and right baffles can adjust.

4.Dust pelletizing system can clean dust quickly.

5.Rubber roller use quick release so as to change quickly.

6.Machine with locks move and install overload protection.

Printing Unit

1.Printing wheel (printing plate form wheel) phase position adjust by planet wheel, twirl 360°adjust electrically, it can stop at operation or stop. PLC control system, setups are return to zero,scrape form memory, automatic reset and phase position adjust after entering values.

2.Printing roller can move from left to right, by ±5MM. printing surface with scale mark make hang form and distance measurement easily.

Anilox roller use “ Haili” to ensure ink distribution effect and printing quality.

Rubber shaft use DongJun, waist drum type, good ink distribution effect and good printing quality.

3.Optional: high reticle ceramic anilox roller with doctor blades, single scrape type, closed scraper cavity. They can save more ink and ensure printing effect.

Slotting Unit

1. With single shaft type slotting, the height of box and phase position will be adjusted electrically. PLC system have automatic knife slotting, restore orders and so on functions, it makes slotting more convenience and high efficiency.

2. Synchronous tool apron is made of high-precision screw with a linear slide rail, which can move left and right stably and precisely so that the slotting cutter can be adjusted smoothly.

3. The copper folk of cutter is designed for automatically compensating gap device, which prolongs the service life of copper fork.

4. Multiple-spacing device is installed in case of knife collision.

Die-cutting Unit

1.Using servo speed to make rubber mat speed and knife tool speed same.

2.To ensure paper boards die-cutter size exactly, to increase die-cutting quality and lengthen rubber mat lifetime.

3.Rubber mat moves from left to right. It can adjust main machine operation speed and Lengthen rubber mat lifetime.

4.Die-cutting roller surface have stainless steel dental crown to fix knife tool.

Stacker

1.Photoelectric system to control bed lifting, safety protection.

2.Strong chain drives, stack height of 1600 mm.

3.Main motor frequency conversion, regulating the paper speed.

4.Independent operation interface, you can choose two types of automatic and manual mode.